Datsun Mini Truckin Homepage
Forum Home Forum Home > Datsun Trucks > 720's
  New Posts New Posts RSS Feed - Need Carburetor expert.  Fuel coming out of vacuum
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Need Carburetor expert. Fuel coming out of vacuum

 Post Reply Post Reply
Author
Message
spddm0n View Drop Down
Newbie
Newbie


Joined: 12 Jun 2019
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote spddm0n Quote  Post ReplyReply Direct Link To This Post Topic: Need Carburetor expert. Fuel coming out of vacuum
    Posted: 12 Jun 2019 at 5:01pm
Hi all - 

I'm new to the community!  

I just picked up an '85 720 King Cab 4X4!  I've been reworking a number of things on the truck and it's starting to look pretty good!


Does anyone know what these two ports on the driver-side of the carburetor are for?  I recently bought an '85 720 KC 4X4 that had the wrong carburetor on it.  It didn't run well.  I picked up the correct carburetor at a salvage yard and a rebuild kit from Napa.  I rebuilt it, along with having the air/fuel ratio solenoid rebuilt by a professional shop.

After installation, I realized I have two ports on the driver-side that aren't connected to anything. I believe they may go to the (high) altitude compensation system, (solenoid mounted on the passenger-side inner fender apron).  I believe I have confirmed the device on the fender apron is in fact just that - the altitude solenoid (for equipped vehicles).

Most of the pics of this carburetor that I can find online, show these two ports capped off.  ??  I found an online reference to an unknown Nissan 720 Service Manual, suggesting these two caps are removed when installing the altitude compensation system.  Pic below.


When I run the engine without anything connected to these two ports, the engine doesn't run well due to a vacuum leak from the lower of the two ports.  When I cap it off, it runs better until the engine warms up and idles down.  Then it stumbles, hesitates and dies.  If I remove the cap, fuel comes out of that port! :)  WTF?!   The upper of the two ports doesn't seem to affect how the engine runs.

I tried running vacuum lines from these ports to the altitude solenoid, but the same issue occurs.  Same problem...the line to the lower port fills up with fuel.

I don't have any vacuum diagrams of the altitude system to suggest which lines go where.  When connecting the vacuum lines up the other way causes the engine to run badly.  

I can't imagine fuel is supposed to be in that line by design.  The hoses appeared to be vacuum hoses, not suitable for fuel.

I removed the carburetor and checked/adjusted the fuel bowl float level.  I believe it is correct.

To determine where the lower port leads to inside the car, I put compress air into it.  It escapes through: 
1 - The jet in the bowl, sourcing fuel to the secondary barrel on the carb.
2 - The nozzle into the venturi in the secondary barrel.
3 - There is also a small hole on the inside of the barrel, toward the top,that also seems to allow some of this compressed air out of it.

Has anyone any expert knowledge of the internal intricacies of this carburetor?  Or, the correct routing of the vacuum lines to these two ports?  Or, experience with the altitude compensation system?

Thanks!
1985 Nissan 720 King Cab 4X4
Back to Top
520KingCab View Drop Down
Junior
Junior


Joined: 23 Mar 2014
Location: Surrey BC
Status: Offline
Points: 43
Post Options Post Options   Thanks (0) Thanks(0)   Quote 520KingCab Quote  Post ReplyReply Direct Link To This Post Posted: 03 Jul 2019 at 10:23pm
Hi there, are you still looking for information? I do have a manual showing it. Thanks, Wayne
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.078 seconds.